LogoLogo
Discord
  • Documentation
  • Projects
  • Changelog
  • Build Instructions
  • Mercury One.1
    • Introduction
    • Bill of material
    • Files
    • Build Instruction
      • Mercury One.1
      • Phase 1
        • Printing
        • Concepts
  • Hydra
    • Introduction
    • Bill of Material
    • Files
    • Build Instruction
      • Phase 1
        • 1. Assembling left arm
  • Nebula
    • Introduction
    • Bill of Material
    • Files
    • Build Instruction
      • Phase 1
        • Gather and Identify Components
      • Phase 2
        • Building the vertical frame
        • Building the side frame
  • External Links
    • Discord
    • Github
Powered by GitBook

Copyright © 2024, ZeroG. All rights reserved. ZeroG by https://zerog.one/ is licensed under a CC BY-NC-SA 4.0 International License.

On this page
  • Lets start with a crucial step: gathering and identifying components and hardware.
  • Hardware
  • Printed parts

Was this helpful?

Edit on GitHub
Export as PDF
  1. Nebula
  2. Build Instruction
  3. Phase 1

Gather and Identify Components

PreviousPhase 1NextPhase 2

Last updated 3 months ago

Was this helpful?

Lets start with a crucial step: gathering and identifying components and hardware.

The Frame - Nebula - is one of the most critical components of your printer. It's important to take your time when assembling to ensure your build goes smooth. If you jump ahead you may miss some very important notes, or worse, end up with an out-of-square frame.

Below is the series of extrusions for the kit. Some are long, some are short, and some look similar but have different features - it is important to note these differences.

Hardware

The hardware displayed below is common to both the 255 and 370 sizes. Only the Quantities will change.

The quantities on this table were purposefully left out. Please reference the correct page for your build size for quantities. This table is to familiarize yourself with the necessary hardware.

Hardware

Type
Image

5X7X8 Bushing

5x50 Pin

6x3 Magnet

10x3 Magnet

M3 Roll In T-nut

M5 Roll In T-Nut

M3 X D5.0 X L4.0 - Heat-set

M3x8 FHCS

M3x8 BHCS

M3x8 SHCS

M3x12 SHCS

M3x14 SHSC

M5x6 BHSC

M5x10 BHSC

M5x10 FHCS

M5x12 SHCS

M5x18 SHCS

M5 Hex Nut

/

3x5mm Foam Tape

/

38x19mm Rubber Foot

Printed parts

*Note* Other filaments may have been used in builds and may work, but the absolute recommendation is ABS/ASA.

We have very specific you should print the parts with, they’ve been designed around these settings. The printed parts are also designed for ABS/ASA shrinkage.

settings